|
 |
RPM
VMEbus Conduction-cooled Pentium-M Single Board Computer
  


|
Features
- Intel® Pentium® M Processor:
- Single-slot VMEbus operation with an on-board compactFlash disk for bootable mass storage
- 855GME and 6300ESB Chipset
- -40°/+85°C operation with 1.4 GHz Pentium M
|
| The RPM is a rugged conduction-cooled
VMEbus (and VME64) compatible platform based on the Intel®
low-power Pentium® M (Dothan) processor. The RPM takes
advantage of the Pentium M's low-power consumption as
a rugged Single Board Computer (SBC) and it is an IEEE
1101.2-compliant, conduction-cooled VMEbus module with
wedge locks and a full-board heat sink for high shock/vibration
environments and temperature extremes.
The RPM is the same board design as the convection-cooled
DPM . The DPM typically uses front panel I/O routing but
can be provided with identical I/O routing as the RPM
for application development in a standard VMEbus chassis.
The 855GME Graphics Memory Controller Hub (GMCH) and
6300ESB I/O Controller Hub (ICH) chipset supports
PCI-X expansion, integrated VGA/DVO interface, USB 2.0,
ATA/100, and Serial ATA (SATA). Two USB 2.0 ports, a COM
port and IDE are all accessible from the rear P2 connector.
SVGA and Digital Vido Output (DVO), dual 10/100/1000BaseT
(VITA 31.1 compatible), dual SATA, and LPC bus are routed
to the optional P0 connector. On-board CompactFlash permits
single-slot booting. One PMC-X site is provided for additional
I/O expansion.
The RPM meets an operating temperature range of -40°/85°
C with it's standard 1.4 GHz Pentium M processor.
The RPM was design for compliance with MIL-Std-810F.
Options include conformal coating. |
Additional Photos

RPM Block Diagram |

Layout |
|
Technical Specifications
| Processor |
2 MB of L2 Advanced Transfer Cache
Available with the Low Voltage at 1.4 GHz @ 10 W
Optional versions available with UltraLowVoltage 1.0 GHz
Celeron M or 1.8 GHz Pentium M |
| Single-slot Operation |
Single-slot VMEbus operation with an on-board compactFlash
disk for bootable mass storage |
| 855GME and 6300ESB Chipset |
400 MT/sec System Bus
Ultra ATA 100/66/33 IDE protocol
PCI-X expansion offers 64 bits @ 66 MHz data transfer
capability
Integrated Graphics
Chipset includes DRAM controller, USB 2.0 interface, two
Serial ATA/150 ports, RTC, NV-RAM, standard PC timers,
Ultra DMA, and interrupt logic |
| DRAM |
DDR-266 support with a memory bandwidth of 2.1 GB/s
Stuffing options for 256MByte, 512MByte or 1GByte
Support ECC
|
| VMEbus |
Tundra Universe IID PCI-VMEbus interface provides 64-
bit VMEbus transfer rates over 30 MB/sec
Full range of software drivers is available for different
operating systems
Full Slot 1 (system controller) functions provided
Lower cost versions available without VMEbus |
| PMC Expansion |
One conduction-cooled PMC-X site with 64 bit @ 66 MHz
bandwidth is available on-board
PMC-P4 is routed in accordance with VITA-35 P4V2- 46dz (PMC-P4
to VME64x-P2-Rows-D,Z) |
| Ethernet |
An Intel 82546 Ethernet controller supports two 10/100/1000BaseTX
Ethernet ports routed to the P0 connector in compliance
with Vita 31.1 for backplane fabric switching or for alternate
routing to an optional rear I/O card |
| Graphics |
The 855GME offers integrated, high-performance graphics
that can support resolutions up to 1600 x 1200 at 85 MHz
DVI-I graphics interface to the P0 backplane connector
PaneLink digital graphic interface combined with a conventional
SVGA analog interfac
Supports a 5 meter cable |
| IDE |
Primary ATA/100 DMA IDE interface is accessible from the
VMEbus P2 connector
PIO and bus master support
Secondary IDE port is routed to a Type II-compatible CompactFlash
connector for on-board booting |
| BIOS |
General Software's flash-based system BIOS with a variety
of boot options, including CD-ROM and PXE over Ethernet
Customized versions available upon request |
| Watchdog |
Programmable watchdog timer for system recovery |
| Conduction-cooling |
Compliant with IEEE 1101.2
Top and bottom cooling plates that are bonded to the major
components through thermal conduction
Wedgelocks secure the RPM in the chassis and bring the module’s
heat from the cooling plates and the PCB |
| Convection-cooled Versions |
For versions compatible with standard VME chassis for
application development, see DPM |
| I/O interfaces |
IDE and PMC I/O (routed through P2)
LPC interface runs through P0
COM2 and two distinct USB 2.0 ports are through P2
Two Serial ATA ports, two 10/100/1000BaseTX ports, are routed
through P0
DVO/VGA routed to P0 |
| Power Consumption |
5 VDC only required
3.5 A @ 5 VDC typical (1.4 GHz Pentium M) |
| Operating Temperature Range |
-40°/+85°C with 1.4 GHz Ultra
Low Voltage Celeron M) |
| Environmental Specs |
Environmental compliance with MIL-STD-810F
|
| Weight |
28.2 oz. with no CompactFlash installed, with 1 GB DDR-267, with P0 and conduction-cooling/stiffener bar installed, without conformal coating |
- Pentium M
- The Intel® Pentium® M processor was designed from
the ground up with a new microarchitecture that delivers high
performance with low power consumption. With its 90 nm processing
technology and 2 MB of L2 advanced transfer cache, the Pentium
M offers more performance per Watt. Second-generation Streaming
SIMD Extensions (Streaming SIMD Extensions 2) capability adds
144 new instructions, including 128-bit SIMD integer arithmetic
and 128-bit SIMD double-precision floating-point operation.
The Pentium. The Pentium M also offers a dedicated hardware
stack manager that employs sophisticated hardware control
for improved stack management, advanced branch prediction
capability, and a 400 MHz front side bus to the memory controller
hub.
- Chipset and 6300ESB ICH C
- The Intel® 855GME Graphics Memory Controller Hub (GMCH)
and Intel® 6300ESB I/O Controller Hub (ICH) chipset create
an optimized integrated graphics solution with a 400 MHz system
bus and integrated 32-bit 3D core at 133 MHz.
- 855GME
- DRAM Controller
The 855GME (GMCH) provides a 266 MHz interface to DDR RAM
(72 bits wide with ECC). The RPM can be populated with one
or two banks of DRAM for 512 MB or 1 GB of total memory respectively.
The GMCH system memory architecture is optimized to maintain
open pages (up to 16-kB page size) across multiple rows. As
a result, up to 16 pages across four rows is supported. To
complement this, the GMCH will tend to keep pages open within
rows, or will only close a single bank on a page miss.
- Graphics Processor
- The 855GME also has an advanced integrated graphical display
controller. The RPM routes the DVO and analog graphics to
P2
- 6300ESB
- The 6300ESB I/O Controller Hub (ICH) provides most of the
RPM's on-board I/O and it's the RPM's PCI-X expansion bridge.
The ICH is designed as a low-power, high-performance I/O hub
that features:
· 64-bit @ 66 MHz PCI-X expansion that is used on the
RPM for the on-board PMC-X slot, the three Ethernet ports
available on the RPM, and for the Universe IID PCI/VMEbus
bridge
· Two USB 2.0 compliant ports routed to the P2 connector
to the backplane
· Integrated IDE controller supports Ultra 100 DMA
Mode Transfers up to 100 MB/sec read cycles and 88.88 MB/sec
write cycles for a CompactFlash drive on-board and a primary
IDE port that is routed through P2 to the RPMPTB
· Two Serial ATA ports providing 150 MB/sec data rates
are routed through P0
· Standard PC functionality like a battery-backed RTC
and 256-bytes of CMOS RAM, Power Management Logic, Interrupt
Controller, Watchdog Timer, AC'97 CODEC, Integrated 16550
compatible UART's, and multimedia timers based on the 82C54
- Intel 82546EB Dual Gigabit Ethernet Controller
- The DHC supports two 10/100/1000BaseTX channels that are
routed to the P0 connector in compliance with the Vita 31.1
Specification for backplane fabric switching. The Intel 82546EB
Dual Port Gigabit Ethernet Controller incorporates two full
Gigabit Ethernet MAC and PHY layer functions on a single,
compact component. Routed from the ICH, the front side data
path to the dual Ethernet port controller is 64 bits at 66
MHz. The Intel 82546EB offers the following features: 10,
100, and 1000BaseTX support with auto-negotiation; Dual 64KB
configurable RX and TX packet FIFOs; 128-bit internal data
path architecture for low latency data handling and superior
DMA transfer rate performance; Built-in Phyceiver.
- Tundra Universe IID CA91C142D PCI-VMEbus Interface
- The PCI-VMEbus interface, based on the Tundra Universe
IID CA91C142D, offers the following features:
· High-performance 64-bit VMEbus interface
· Integral FIFOs for write-posting allow the Universe
IID to quickly relinquish the bus
· Programmable DMA controller with linked list support
· Full VMEbus system controller functionality
· Complete VMEbus address and data transfer modes:
A32/A24/A16 master and slave; D64 (MBLT)/D32/D16/D08 master
and slave
RPM I/O Routing
| I/O |
Through P0 |
P2 |
| DVI-I Graphics |
1+ |
|
| Serial ATA |
2 |
|
| AC'97 CODEC |
1 |
|
| Gb Ethernet |
2 (VITA 31.1) |
|
| RS-232 COM 2 Port |
|
1 |
| USB 2.0 |
|
2 |
| IDE Interface |
|
1 |
Ordering Information
| Part# |
Description |
| RPMxQPGx |
Conduction-cooled VME64 Single-slot CPU board with 1.4
GHz Pentium-M. 1 GB DDR-267 DRAM. COM2, 2x USB 2.0 and IDE
routed to P2. PCI-X compatible PMC site with front and rear
access. Support for up to 4 GB bootable CompactFlash. Dual
10/100/1000BaseT, dual SATA, and DVI-I/VGA routed to P0.
VITA 31.1 compliant. LPC routed to P0 . -40°/+85°C
operation. |
| xPMQxxxx |
256 MB Flash for RPM |
| xPMRxxxx |
512 MB Flash for RPM |
| xPMSxxxx |
1 GB Flash for RPM |
| xPMTxxxx |
2 GB Flash for RPM |
| xPMUxxxx |
4 GB Flash for RPM |
| xPMVxxxx |
8 GB Flash for RPM |
| XPMxxxxx-ER |
Chamber testing to customer thermal profile |
| CONCOAT-XPM |
Conformal coating |
| DSW-500- RPM |
VxWorks BSP (one time charge) |
| DSW-700-RPM |
DriveVME, a high-performance VME-to-Windows/NT
Systems Software Link (Development version) |
| DSW-700-RPM |
DriveVME, a high-performance VME-to-Windows/NT Systems
Software Link (Development version) |
| DSW-700XP-RPM |
DriveVME for Windows XP |
| DSW-7002K-RPM |
DriveVME for Windows 2000 |
| DSW-900-RPM |
BSP for QNX |
| DSW-B00-RPM |
BSP for Linux (Redhat Linux or other distributions upon
request) |
| DSW-RTX-RPM |
RTX driver for VMEbus (Tundra Universe 2) |
back to top
|
 |
|