|
 |
CPU 111-10 (VPQ)
Intel Quad-Core based VPX SBC with 24-port 10 Gb ENET Switch
   
CPU 111-10
Click to Enlarge
|
Features
- Open VPX compatible profile MOD6-PAY-4F2T-12.2.2.4
- Intel®Quad Core L5408 Processor @ 2.13 Hz
- Support VITA 46.21 for full mesh 10 Gb XAUI interconnect up to 5 boards on backplane per VITA 46.7 (Ethernet on VPX Fabric Connector)
- Seven 10 Gb XAUI total ports to the backplane for full mesh support
- On board Fulcrum 24 port 10 Gb Rthernet XAUI switch (also available without switch)
- On-board PCI express SVGA Controller
- Front panel SFP+ 10 Gb copper or optical for chassis to chassis interconnect
- Supports two fully capable PMC/XMC Sites with PCI-X speeds of up to 133MHz and PCIe x8. Additionally, each XMC site provides a 10G XAUI lane to the on-board 24-port switch enabling an XMC card to be part of the 10G fabric
- Available in conduction cooled versions for rugged applications
- On board 4 GB DDR2 and 16 GB bootable Flash disk
- OS support for Linux, VxWorks, Windows, Solaris, LynxOS, QNX
|
Introduction:
The CPU 111-10 is a high performance Single Board Computer (SBC) based on the 6U VPX (VITA 46) form factor. It is Open VPX compatible per profile MOD6-PAY-4F2T-12.2.2.4. This profile indicates a 6U Payload Module having 4 fat pipes (10 GBase-BX4) and two thin pipes (1000Base-T).
Offered in both convection cooled and ruggedized conduction cooled variants, the CPU 111-10 will meet the needs of numerous commercial and military applications.
At the heart of the CPU 111-10 is one quad-core Intel L5408 Xeon Processor, an Intel 5100 Memory Controller Hub (MCH), and an Intel ICH9R I/O Controller Hub (ICH), forming the central processing backbone of the design. Up to 4 GBytes of DDR2 SDRAM are supported with the MCH running at up to 1066 MHz double data rate speeds.
The CPU 111-10 provides unparalleled data processing capabilities. It supports two fully capable PMC/XMC Sites with extensive User I/O. An on-board Fulcrum FM3224 24-Port 10 Gigabit Ethernet Switch provides full-mesh backplane data-layer interconnectivity, allowing up to eight CPU 111-10 SBC's to be integrated into a single chassis without the use of an additional switch board. A PLX PEX8624 PCI Express Switch provides connectivity to the XMC Sites and an Intel 82599EB Dual 10 Gigabit Ethernet controller, which connects to the 10 Gigabit Ethernet Switch. The Intel 82599EB supports the IEEE 1588 Precision Time Protocol standard allowing all node boards to be synchronized in the sub-microsecond range. An 82571EB Dual 1Gigabit Ethernet controller provides 1000Base-T or 1000BASE-KX connectivity to the backplane via the VPX P4 connector.
For convection cooled applications, the CPU 111-10 provides a front panel SFP+ port supporting CX4 copper and Fiber applications for chassis-to-chassis and rack-to-rack communications.
On-board non-volatile storage includes a 16 GByte Solid State Flash Drive, 16 Mbit SPI flash memory, and a 16 Mbit Firmware Hub. Four SATA, two USB, VGA, and an RS232 or RS485 Console port complement the CPU 111-10 I/O through the backplane or rear transition module.
|
|
Technical Specifications
| CPU |
One Intel quad-core L5408 Xeon Processor running at 2.13 GHz
32KB L1 Instruction and 32KB L1 Data Cache per core
12MB L2 Cache (shared)
1066/1333 MHz Front Side Bus supporting 8.5 GByte/Sec transfer rates |
Memory Controller Hub (MCH) |
Intel 5100 MCH with 1066/1333 MHz Front Side Bus
4GB DDR2 SDRAM at 533/667 MHz (1066 MHz DDR)
Two x8 PCI Express Ports to XMC Sites
One x8 PCI Express Port to PEX8624 Gen 2 PCIe Switch |
I/O Controller Hub (ICH9R) |
Four Serial ATA Ports to VPX P4 Connector
Two USB Ports to VPX P4 Connector
LPC Bus to 16Mbit Firmware Hub
16Mbit SPI Flash
RS232/RS485 Serial Communications to VPX P4 Connector
32-Bit PCI Interface supports SM712 VGA Controller
Real-time clock with 256 bytes of battery-backed RAM |
PLX PEX8624 PCI Express Switch |
One x8 PCI Express Port to MCH
Two x4 PCI Express Ports to two Tsi384 PCI-X
Bridges to support PMC sites
One x8 PCI Express Port to an Intel 82599EB (Niantic) Dual 10-Gigabit Ethernet Controller providing connectivity to 10Gigabit Ethernet Switch |
Fulcrum FM3224 24-Port 10Gigabit Ethernet Switch |
300nS Latency
Layer 2 Functionality
Advanced Policy Engine
Switch Virtualization and Scaling
Port and MAC Based Security
In-band Switch Management
Provides Full-Mesh connectivity between up to eight CPU 111-10 Node Boards
Front Panel SFP+ Connector for Copper or Fiber Optic cables (Configuration dependent)
Lower power, lower cost versions available without switch, with two 10 Gb XAUI Ethernet routed directly to P1 |
Intel 82599EB Dual 10 Gigabit Ethernet Controller |
Complies with 10Gb/Sec Ethernet/802.3ae (XAUI)
x8 Gen2 PCI Express interface
IEEE1588 Precision Time Protocol (PTP) support
4-Wire SPI EEPROM Interface |
Intel 82571EB Dual 1 Gigabit Ethernet Controller |
Complies with 1Gb/Sec Ethernet/802.3ap
x4 PCI Express interface to ICH9R
MDII or SERDES interface to backplane
4-Wire SPI EEPROM Interface |
SM750 VGA Controller |
Connects to ICH9R via x1 PCI Express Interface
16MByte Internal DDR SDRAM Video Memory
2D Graphics Accelerator |
| NetLogic Puma AEL2006 10GigE PHY/SerDes |
Specifically targeted for SFP+ applications
Meets 10GBASE-LRM requirements
Multiple Loopback Modes
Adjustable XAUI transmit pre-emphasis
On-chip clock generation and data recovery |
Tsi384 PCI Express to PCI-X Bridge |
64-bit 133 MHz PCI-X operation
Forward Bridge Operation
3.3V PCI-X I/O
Legacy interrupt signaling and MSI interrupt support |
Dual PMC/XMC Sites |
Individual 133MHz 64-bit PCI-X Busses to J11-J13 and
J21-J23 supporting legacy PMC Modules (3.3VIO only)
Individual x8 PCI Express Busses from MCH to XMC Connectors J15 and J25
XAUI Fat-Pipe connectivity from FM3212 to XMC P16 and P26
Single-Ended x64 User I/O connectivity from PMC J14 and J24 to VPX P3 and P6, respectively
Differential x12 User I/O connectivity from XMC J16 and J26 to VPX P2 and P5, respectively |
VPX Rear I/O |
P0 Utility Connectivity per VITA 46.0
P1 XAUI Fabric Connectivity per VITA 46.21
P2 XMC J16 Differential Connectivity (12 pairs) per VITA 46.9, XAUI Fat-Pipe connectivity from FM3212
P3 PMC J14 Single-Ended Connectivity per VITA 46.9
P4 Module Specific I/O to CPU 111-10 RTM or backplane
P5 XMC J26 Differential Connectivity (12 pairs) per VITA 46.9, XAUI Fat-Pipe connectivity from FM3212
P6 PMC J24 Single-Ended Connectivity per VITA 46.9 |
Non-Volatile Storage |
16Mbit EEPROM on ICH9R SPI bus
16Mbit Firmware Hub on ICH9R LPC Bus
16Mbit EEPROM on FM3212 10 Gigabit Ethernet Switch for initial configuration
16GByte Solid State Flash Drive |
Power Consumption |
+5V @ 29A Max, 21.2A Typ (Estimate)
+12V @ 4.4A Max, 2.9A Typ (Estimate)
Total Power: 198W Max, 141W Typ (Estimate)
Actual power depends on CPU 111-10 product configuration |
Form Factor |
6U VITA 46 VPX |
Rugged/Conduction Cooled |
The CPU 111-10 is offered in conduction-cooled versions
Coduction-cooled versions include wedge locks which
provide high shock and vibration immunity per MIL-STD-810F
Convection and Conduction cooled versions have conformal coating as an option |
-
CPU 111-10 I/O Routing
I/O |
Front Panel |
P1 |
P2 |
P3 |
P4 |
P5 |
P6 |
SFP+ Interface |
1 |
|
|
|
|
|
|
10 Gb Ethernet (XAUI) |
|
4 |
1 |
|
1 |
1 |
|
10 Gb Ethernet (MDII) |
|
|
|
|
2 |
|
|
1 Gb Ethernet (SERDES) |
|
|
|
|
2 |
|
|
XMC Site 1 |
|
|
12 Diff Pairs |
|
|
|
|
XMC Site 2 |
|
|
|
|
|
12 Diff Pairs |
|
PMC Site 1 |
|
|
|
64 Single Ended |
|
|
|
PMC Site 2 |
|
|
|
|
|
|
64 Single Ended |
Serial ATA |
|
|
|
|
4 |
|
|
USB 2.0 |
|
|
|
|
2 |
|
|
SVGA |
|
|
|
|
1 |
|
|
RS-232/485 |
|
|
|
|
1 |
|
|
CPU 111-10 Ordering Information
Part#
|
Description |
| CPU
111-10-00 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, with 12-port
10 Gb Switch, 0 to +77C - Convection cooling |
| CPU
111-10-01 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, with 12-port
10 Gb Switch, ext temp range - Convection cooling |
| CPU
111-10-02 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, with 12-port
10 Gb Switch, ext temp range - Conduction cooling |
| |
|
| CPU
111-10-03 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, without
12-port 10 Gb Switch, 0 to +77C - Convection cooling |
| CPU
111-10-04 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, without
12-port 10 Gb Switch, ext temp range - Convection cooling |
| CPU
111-10-05 |
2.13
GHz Quad Core, 4 GB DRAM memory down, No Flash, without
12-port 10 Gb Switch, ext temp range - Conduction cooling |
| |
|
| S10
10-11-00 |
Conformal
coating option for 6U board |
| |
|
| CPU
111-10-RT00 |
Rear
Transition module |
back to top
|
|
|
CPU 111-10
Drawing 
